Board Index Getting Started Website Help

Ruger mini-14

Read about whats new and improved on the site, or make suggestions about how we can make the website better.

Ruger mini-14

Postby graytruck » Fri Dec 09, 2011 2:25 pm

I just bought a mini-14 and the trigger pull was more than I like.

I took the trigger assembly out and then took the trigger off.

There is a return spring that hooks on a pin, on each side of the trigger.

I hooked one side of the spring on the pin and left the other side unhooked.

Doing that and a little grease on the release mechanism and the trigger pull is about half of what it was and the trigger returns just fine.

Does anyone thing this will hurt anything ?
Posts: 1
Joined: Fri Dec 09, 2011 2:16 pm

Return to Website Help

Users browsing this forum: No registered users and 1 guest