Help please

Discussion in 'Gun Chatter' started by michiganjim, Feb 8, 2011.

  1. michiganjim

    michiganjim New Member

    I posted this in the wrong place so trying again.

    Before going to a gun shop, I thought someone here might help. I purchased a Ruger P95 last year. I really like it. Over 500 rounds and not a single jamb or miss fire. I've cleaned it twice between use, and, then it sat for a few months. At the range yesterday, I fired a couple hundred rounds. Today, I disassembled and cleaned it again.

    Now, it is stuck halfway back together. The slide is caught, the barrel and camblock are sticking out the front. Slide only moves back about 3/4". Pin (slide stop) is not in.

    I have the book open in front of me and thought I was doing it right like i did twice before.

    Any suggestions?
  2. BrianB

    BrianB Well-Known Member

    I don't have a P95, my only thought to suggest would perhaps be to try calling Ruger and see if they could help you figure it out over the phone.

  3. smith6906

    smith6906 Well-Known Member

    sounds like your pinblock in the slide is stuck to your trigger pin above the trigger housing. try *if you know how to reassemble the trigger assembly* to use a punch to knock out the big pin right above the trigger, if you dont feel compfortable doing that, i would recommend going to your local gun shop and having them do it for ya :)