>
Board Index Gear and Ammo Gunsmithing

Help - Accu-Tek AT380 reassembly

Discuss cleaning or modification of your weapon in order to maintain or upgrade reliability and performance.

Help - Accu-Tek AT380 reassembly

Postby Danger » Thu Jan 20, 2011 9:15 pm

I was celaning a neighbor's 380 and had seperated the slide and barrel from the frame. When I turned the frame upside down a small part about 1 inch long shaped like an 'L' fell out. I have no idea where this goes or what it is. I have a photo, if someone can provide me some guidance as to how to properly place the part. My email is allenhyman@comcast.net.

Thanks,



Danger
Danger
 
Posts: 2
Joined: Thu Jan 20, 2011 8:25 pm

Postby Shadow74 » Sat Jan 22, 2011 8:30 pm

I can't find a schematic of the .AT380 but I did find one of the .25auto. Look at this schematic and see if you can determine the placement of your mystery piece! My money is on the Magazine Catch Spring, the Sear Spring shouldn't have fallen out unless you did some major disassembly of the pistol. Good luck Danger!

http://www.gunpartscorp.com/catalog/Products.aspx?catid=982
Shadow74
 
Posts: 26
Joined: Sun Jun 27, 2010 8:23 pm

Postby Danger » Sun Jan 23, 2011 12:00 am

Thanks Shadow 74

I looked at a diagram I found on the web and was able to fit it properly.

Thanks for the help.

Danger
Danger
 
Posts: 2
Joined: Thu Jan 20, 2011 8:25 pm


Return to Gunsmithing

Users browsing this forum: No registered users and 2 guests

cron